Traffic Facilities | Introduction to and Characteristics of Blow Molding
The mainstream method for manufacturing blow-molded products for the transportation industry is extrusion blow molding (EBM). The primary raw material is UV-modified HDPE (high-density polyethylene), with some formulations incorporating LLDPE to enhance low-temperature toughness. Typical products include blow-molded water barriers, crash barrels, traffic barriers, traffic cone housings, warning buoys, and small traffic storage boxes.
Suitable for blow molding:
temporary construction water barriers, simple crash barrels, short-term road barriers, temporary warning buoys, and small roadblock housings (for municipal emergency repairs, temporary road closures for events, and temporary traffic diversion in parking lots)
I. Process Flow
1. Plastic extrusion: HDPE plastic pellets are heated until molten, and extruded into tubular parisons;
2. Mold Clamping: The split mold clamps the sagging, high-temperature green body;
3. Blow molding: Compressed air is introduced to inflate the preform so that it fits snugly against the inner wall of the mold, forming a one-piece hollow shell (with cavities reserved for filling with water or sand, and impact protection achieved through counterweights);
4. Cooling and Trimming: The mold is water-cooled to set its shape; flash from the mold closure is trimmed; water inlet and outlet holes, as well as grooves for reflective strips, are machined;
5. Final Assembly: Apply reflective film, install connecting clips, and check for leaks.
II. Key Features and Advantages
1. One-piece, hollow, seamless design; can be filled with water for ballast
The shell has no seams, ensuring a tight seal; when filled with water and sand, its weight increases, providing cushioning and isolation. The empty barrels are lightweight, making them easy to transport, stack, and store, and ideal for rapid deployment in temporary construction projects.
2. Fast mass production and high cost-effectiveness
With short molding cycles and a high degree of automation, this process is well-suited for emergency municipal repairs and large-volume stockpiling for temporary roads; mold costs are lower than those of rotomolding, making it ideal for low-cost procurement needs in short-term projects.
3. Good weather resistance
When UV-resistant and anti-aging additives are added, the material is less prone to rapid aging when exposed to outdoor sunlight or extreme temperatures; the PE material is resistant to rain, acids, and alkalis, and does not rust easily.
4. Integrated Mold Structures
Structures such as snap fasteners, reflective grooves, and handles can be molded directly as a single unit, eliminating the need for extensive secondary processing; these standardized products offer high versatility.
5. The material is recyclable
PE material is recyclable and meets municipal green procurement requirements.
Contact Us at Any Time